High tensile gum rubber insert with antiozonant added for long life.ĥ.
Ends of steel hooks interlocked and swaged in place to provide failsafe construction.Ģ. The maximum recommended steady loads shown are not failure points, but represent loads that, when exceeded for long periods of time, may cause the isolator to take a “permanent set” there- by reducing the efficiency of the system.ġ. Choosing isolators for a much greater load to be “safe” will result is a less efficient system. It is therefore very important to choose isolators that will provide the maximum static deflection for the load to be supported. The greater the static deflection, the greater the isolation efficiency (see the chart below). The static deflection is how much the isolators compress under the weight of the equipment. One of the most important factors when determining the efficiency of a system is the static deflection of the isolators. There are many fine independent acoustical consultants who, with the help of specialized equipment, are able to pinpoint exactly what is required to solve any specific problem. Some of them are the vibration disturbing frequency and amplitude, the mass of the suspended system, the isolator static deflection and effective spring rate and the criticality of the location. The choice of vibration isolators must take many factors into consideration. Rubber collars shall be provided at the points where the wire forms pass through the pressure plates to prevent metal-to-metal contact. The metal structural portion of the Acoustic Isolation Hangers shall be 11 gauge zinc coated steel wire forms interlocked through holes in zinc coated steel pressure plates and swaged in place to provide failsafe construction. The isolation medium shall be high tensile gum rubber, to assure resilience, with an anti-ozonant added, to assure long life. In order to reduce these effects, a completely resiliant material must be interposed in the system.Īcoustic Isolation Hangers shall be incorporated, in series, into the suspension system at all points of support. Just the opposite is the situation with air ducts and piping in that vibration from air handling units and pumps is transmitted to the building structure. Hung ceilings, because of the nature of their construction, tend to act as sounding boards and amplify the noises and vibrations that are transmitted down from the building structure through the suspension wires. Acoustic Isolation Hangers are designed to reduce noises and vibrations that are transmitted down from the building structure through suspension wires, air ducts, and piping.
0 kommentar(er)
